138
Changing charac-
teristic parame-
ters
Call up "Optimizing & managing characteristics" menu item
– The last "Data" screen called up appears.
Press F1 "Managing characteristics" and select the corresponding characteristic
Whatever screen is showing, use the right arrow key (8) to select the "Data" screen in
which the characteristic parameter to be changed is located
Using F2 or F5, select the characteristic point whose characteristic parameter is to be
changed:
– F2 "Previous point" ... the characteristic point before the current one appears.
The first point in the characteristic, F2 "Previous point" is greyed out.
– F5 "Next point" ... the characteristic point after the current one appears.
With the last point in the characteristic, F5 "Next point" is greyed out.
Select the characteristic parameter to be changed using the down (6) or up (7) key
Use the adjusting dial (18) to alter the parameter value
A parameter value can only be altered within the defined setting range. The setting range
is highlighted.
Example:
The characteristic parameter "Droplet-detachment
time" will be changed for point 2 of the characteristic
CrNi188 08 M21 mod in the "Pulsing parameters"
screen
1
2
3
4
5
6
To Next Page
Loading...