Fronius RCU 5000i - Setting Machine Pre-Sets for Welding; Setting Machine Pre-Sets for MIG;MAG; Setting Machine Pre-Sets for TIG

156
Setting machine pre-sets for welding
Setting machine
pre-sets for "MIG/
MAG"
Machine pre-sets: "MIG/MAG" screen
Call up the "Machine pre-sets" menu
item
Select "MIG/MAG" screen by pressing
the right arrow key (8)
– "MIG/MAG" screen appears
Select the corresponding pre-set using
down (6) or up (7) keys
Alter the value of the pre-sets using the
adjusting dial (18)
– A pre-set value can only be alte-
red within the defined setting ran-
ge. The setting range is
highlighted.
Setting machine
pre-sets for "TIG"
Machine pre-sets: "TIG" screen
Call up the "Machine pre-sets" menu
item
Select "TIG" screen by pressing the
right arrow key (8)
– "TIG" screen appears
Select the corresponding pre-set using
down (6) or up (7) keys
Alter the value of the pre-sets using the
adjusting dial (18)
– The "Comfort Stop sensitivity" pre-
set only appears if the "TCS - TIG
Comfort Stop" option is installed
on the power source.
– A pre-set value can only be alte-
red within the defined setting ran-
ge. The setting range is
highlighted.
1
2
3
4
1
2
3
4