© 2011 Fujitsu Technology Solutions
188
Forwarding State - The port's current state Spanning Tree state. This state controls what action a
port takes on receipt of a frame. If the bridge detects a malfunctioning port it will place that port into
the broken state. The other five states are defined in IEEE 802.1D:
• Disabled
• Blocking
• Listening
• Learning
• Forwarding
• Broken
Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree.
The port role will be one of the following values: Root Port, Designated Port, Alternate Port, Backup
Port, Master Port or Disabled Port.
Admin Mode - The Port control administration state. The port must be enabled in order for it to be
allowed into the network. The factory default is enabled.
E-Keying Status - Indicates the E-Keying status of the port.
LACP Mode - Indicates the Link Aggregation Control Protocol administration state. The mode must
be enabled in order for the port to participate in Link Aggregation.
Physical Mode - Indicates The port speed and duplex mode. In auto-negotiation mode the duplex
mode and speed are set from the auto-negotiation process.
Physical Status - Indicates the port speed and duplex mode.
Link Status - Indicates whether the Link is up or down.
Link Trap - Indicates whether or not the port will send a trap when link status changes.
ifIndex - Indicates the ifIndex of the interface table entry associated with this port.
Flow Control - Indicates the status of flow control on this port.
Broadcast Storm Control - Indicate the status of the broadcast storm control, disable or its rate.
Multicast Storm Control - Indicate the status of the multicast storm control, disable or its rate.
Unicast Storm Control - Indicate the status of the unicast storm control, disable or its rate.
Storm Control Action - Indicates the status of storm control action shutdown/trap is enabled or
disabled.
Capability - Indicates the port capabilities during auto-negotiation.
Port Description - Indicates the port description.
Command Buttons
Refresh - Re-fetch the configuration value again.
To Next Page
Loading...
