© 2011 Fujitsu Technology Solutions
340
9.5.2.3 Priority Mapping
Figure : Class of Service Priority Mapping
Selection Criteria
Slot/Port - Select the physical interface for which you want to display or configure data. Select 'All' to
set the parameters for all ports to the same values.
Configurable Data
Traffic Class - Specify which internal traffic class to map the corresponding 802.1p priority.
Non-Configurable Data
802.1p Priority - Displays the 802.1p priority to be mapped.
Command Buttons
Apply - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Restore Defaults - Restores default settings.
To Next Page
Loading...
