Fujitsu PRIMERGY BX900 - Page 475

© 2011 Fujitsu Technology Solutions
473
10.4.10.3 port-channel
This command configures a new port-channel (LAG) and generates a logical slot and port number for it.
Note: Before including a port in a port-channel, set the port physical mode. See ‘speed-duplex’
command.
Syntax
port-channel <name>
no port-channel {<slot/port> | all}
<logical slot/port> - Port-Channel Interface number.
<name> - Port-Channel name (up to 15 alphanumeric characters).
all - all Port-Channel interfaces.
no - This command removes that Port-Channel.
Default Setting
None
Command Mode
Global Config
Command Usage
Max number of port-channels could be created by user are 64. Number of members for each
port-channel are 8.
10.4.10.4 port-channel adminmode all
This command sets every configured port-channel with the same administrative mode setting.
Syntax
port-channel adminmode all
no port-channel adminmode all
no - This command disables a port-channel (LAG). The option all sets every configured port-channel
with the same administrative mode setting.
Default Setting
Enabled
Command Mode
Global Config