Fujitsu PRIMERGY BX900 - Page 477

© 2011 Fujitsu Technology Solutions
475
10.4.10.7 port-channel load-balance
This command for CLI will configured the mode of load balance on the all Port Channels. The parameter
“src-mac | dst-mac | src-dst-mac | src-ip | dst-ip| src-dst-ip” represent the mode used to be set for
port-channel load balance.
Syntax
port-channel load-balance all { src-mac| dst-mac | src-dst-mac | src-ip | dst-ip| src-dst-ip }
no port-channel load-balance all
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
src-dst-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
src-dst-ip - Sets the mode on the source and destination IP addresses.
no - Restore the mode to be default value.
Default Setting
src-dst-mac
Command Mode
Global Config
10.4.10.8 adminmode
This command enables a port-channel (LAG) members. The interface is a logical slot and port for a
configured port-channel.
Syntax
adminmode
no adminmode
no - This command disables a configured port-channel (LAG).
Default Setting
Enabled
Command Mode
Interface Config