GE Giraffe OmniBed Service Manual

List of Figures
Figure 1-1 Block Diagram ........................................................................................................................................ 2
Figure 1-2 Humidier .................................................................................................................................................9
Figure 2-1 Connections and Controls .............................................................................................................. 18
Figure 3-1 Control Board Test Points ............................................................................................................... 22
Figure 4-1 First Service Screen ........................................................................................................................... 30
Figure 4-2 Second Service Screen .................................................................................................................... 31
Figure 4-3 Status Menu .......................................................................................................................................... 31
Figure 4-4 Switch Diagnostic Diagram ........................................................................................................... 32
Figure 4-5 Pedal Screen ......................................................................................................................................... 32
Figure 4-6 Service Screen ..................................................................................................................................... 33
Figure 4-7 Servo Controlled Oxygen Service Screen ................................................................................ 65
Figure 5-1 Heater Housing Cover and Sot ................................................................................................ 72
Figure 5-2 Original Seal Parts .............................................................................................................................. 73
Figure 5-3 Nuts........................................................................................................................................................... 73
Figure 5-4 Access Holes ......................................................................................................................................... 74
Figure 5-5 Canopy, Bracket, and Heater Housing..................................................................................... 74
Figure 5-6 Two People Needed for this Step ................................................................................................ 75
Figure 5-7 Canopy Seals and Extrusions ....................................................................................................... 76
Figure 5-8 Wedging a Blunt Object to Keep Seal Open .......................................................................... 77
Figure 5-9 Enhanced Seal Parts ......................................................................................................................... 78
Figure 5-10 West Side Seal Parts....................................................................................................................... 79
Figure 5-11 Using North Seal to Help Position Washers ........................................................................ 79
Figure 5-12 Seal Cross-section ........................................................................................................................... 80
Figure 5-13 North Seal Parts ............................................................................................................................... 81
Figure 5-14 Beveled Side of North Spacer Toward Canopy .................................................................. 81
Figure 5-15 Hole Fill Assembly (2x) for Canopies with Six Holes across North End ................... 82
Figure 5-16 South Seal Parts ............................................................................................................................... 83
Figure 5-17 South Corner Parts .......................................................................................................................... 84
Figure 5-18 North Corner Parts .......................................................................................................................... 84
Figure 5-19 Installing Rail Spacers.................................................................................................................... 85
Figure 5-21 Sot ....................................................................................................................................................... 87
© 2001 by Datex-Ohmeda, Inc.. All rights reserved. 6600-0343-000 104 xi

GE Giraffe OmniBed Specifications

General

Temperature Control	Yes
Humidity Control	Yes
Servo Humidity Control	Yes
Oxygen Delivery	Yes
Scale	Integrated
Trendelenburg/Reverse Trendelenburg	±12°
Rotating Mattress	No
X-ray Compatibility	Yes
Mobility	Yes, with casters
Category	Incubator
Humidity Range	30% to 95%
Oxygen Hood	Yes
Access Ports	Multiple
Modes	Air Mode, Skin Mode
Power Requirements	100-240V AC, 50/60 Hz