GE Giraffe OmniBed Service Manual

Figure 5-22 Trimming the Sot.......................................................................................................................... 87
Figure 5-23 Untrimmed and Trimmed Sot ................................................................................................ 88
Figure 5-24 Disconnecting Heater Door Cable ........................................................................................... 91
Figure 5-25 Upright Decorative Strips, End Caps, and Wire Covers .................................................. 92
Figure 5-26 Removing the Lift Motor ............................................................................................................... 93
Figure 5-27 Display Module Disassembly ...................................................................................................... 93
Figure 5-28 Right Upright Disassembly .......................................................................................................... 96
Figure 5-29 Rollers and Tensioning Spring ................................................................................................... 97
Figure 5-30 Replacing the Drive Belt ............................................................................................................... 98
Figure 5-31 Replacing the Rail Buoyancy Springs ..................................................................................... 99
Figure 5-32 Left Inner Rail ...................................................................................................................................102
Figure 5-33 Left Rail Springs and Spools .....................................................................................................103
Figure 5-34 Re-attaching the Upright ...........................................................................................................104
Figure 5-35 Cable Guard Latch ........................................................................................................................107
Figure 5-36 3-pin MAT-N-LOK Connector and Bushing ........................................................................107
Figure 5-37 Cable Tie ............................................................................................................................................108
Figure 5-38 Connector Drawing ......................................................................................................................109
Figure 5-39 Opened Cable Guard Latches ..................................................................................................109
Figure 5-40 Correct and Incorrect Cable Tie Usage ...............................................................................110
Figure 5-41 Lift Rail and Cable Carrier Channel Together ..................................................................110
Figure 5-42 Canopy Alignment .........................................................................................................................112
Figure 5-43 Radiant Heater Disassembly ....................................................................................................114
Figure 5-44 Heater Door Cable Adjustment ...............................................................................................116
Figure 5-45 Securing String to the Spring Tube ........................................................................................118
Figure 5-46 Removal of the Lower M5 Nut .................................................................................................119
Figure 5-47 Dog Point of the Set Screw ........................................................................................................120
Figure 5-48 Compartment Air Probe Disassembly ..................................................................................121
Figure 5-49 Top Rail End Cap ............................................................................................................................122
Figure 5-50 Bed Disassembly ............................................................................................................................124
Figure 5-51 Heat Sink and Fan .........................................................................................................................125
Figure 5-52 Fan Motor ..........................................................................................................................................125
Figure 5-53 Elevating Base .................................................................................................................................126
Figure 5-54 Chassis Bottom Cover .................................................................................................................129
Figure 5-55 Replacing the Tilt Brake Pad .....................................................................................................132
Figure 5-56 Humidier Parts ..............................................................................................................................135
Figure 5-57 Display Module ...............................................................................................................................137
Figure 5-58 Probe Panel ......................................................................................................................................138
xii 6600-0343-000 104 © 2001 by Datex-Ohmeda, Inc.. All rights reserved.
List of Figures

GE Giraffe OmniBed Specifications

General

Temperature Control	Yes
Humidity Control	Yes
Servo Humidity Control	Yes
Oxygen Delivery	Yes
Scale	Integrated
Trendelenburg/Reverse Trendelenburg	±12°
Rotating Mattress	No
X-ray Compatibility	Yes
Mobility	Yes, with casters
Category	Incubator
Humidity Range	30% to 95%
Oxygen Hood	Yes
Access Ports	Multiple
Modes	Air Mode, Skin Mode
Power Requirements	100-240V AC, 50/60 Hz