GE Giraffe OmniBed Service Manual

Figure 5-59 Electronics Enclosure ...................................................................................................................140
Figure 5-60 Installing Sensors ...........................................................................................................................143
Figure 5-61 Sensor Housing...............................................................................................................................144
Figure 5-62 Valve Housing..................................................................................................................................146
Figure 5-63 Endcap Safety Valve .....................................................................................................................147
Figure 6-1 Probe Panel Assembly ....................................................................................................................151
Figure 6-2 Display Module ..................................................................................................................................153
Figure 6-3 Electrical Enclosure .........................................................................................................................155
Figure 6-4 Humidier Transformer and RS232 Option ..........................................................................157
Figure 6-5 Bed .........................................................................................................................................................159
Figure 6-6 Side Panel (East/West)....................................................................................................................161
Figure 6-7 Rear (North) and Front (South) Wall .........................................................................................163
Figure 6-8 Radiant Heater ..................................................................................................................................165
Figure 6-9 Canopy .................................................................................................................................................167
Figure 6-10 Original Canopy Seal Parts........................................................................................................168
Figure 6-11 Enhanced Canopy Seal Parts ...................................................................................................169
Figure 6-12 Heater Doors ..................................................................................................................................171
Figure 6-13 Upper Chassis ................................................................................................................................173
Figure 6-14 Lower Chassis ................................................................................................................................175
Figure 6-15 Humidier Assembly ....................................................................................................................177
Figure 6-16 Base and Elevating Column ......................................................................................................179
Figure 6-17 Right (East) Upright Parts, Motor Side (Complete East Rail Assembly: 6600-0290-850)
181
Figure 6-18 Belt Channel - 1 (Lift Motor Side) ............................................................................................183
Figure 6-19 Belt Channel - 2 (Lift Motor Side) ............................................................................................185
Figure 6-20 Lift Rail (Both Sides) .......................................................................................................................187
Figure 6-21 Rail End Caps ..................................................................................................................................189
Figure 6-22 Left (West) Upright (Complete West Rail Assembly: 6600-0290-851) ...................191
Figure 6-23 Compartment Air Probe..............................................................................................................193
Figure 6-24 Servo Control Oxygen Sensor Housing Assembly (Servo O2 Upgrade Kit 6600-0678-800)
195
Figure 6-25 Servo Control Oxygen Valve Housing .................................................................................197
Figure 6-26 Expansion Chamber/Heatsink Vent ......................................................................................198
Figure 6-27 Servo Control Oxygen Cooling Fan ........................................................................................199
Figure 6-28 Servo Control Oxygen PC Board .............................................................................................200
Figure 6-29 Manifold Endcap Safety Valve .................................................................................................201
Figure 6-30 Storage Drawer .............................................................................................................................202
© 2001 by Datex-Ohmeda, Inc.. All rights reserved. 6600-0343-000 104 xiii
List of Figures

GE Giraffe OmniBed Specifications

General

Temperature Control	Yes
Humidity Control	Yes
Servo Humidity Control	Yes
Oxygen Delivery	Yes
Scale	Integrated
Trendelenburg/Reverse Trendelenburg	±12°
Rotating Mattress	No
X-ray Compatibility	Yes
Mobility	Yes, with casters
Category	Incubator
Humidity Range	30% to 95%
Oxygen Hood	Yes
Access Ports	Multiple
Modes	Air Mode, Skin Mode
Power Requirements	100-240V AC, 50/60 Hz