4-3
Supplement
Coordinate value displayed here is the
distance to the tool carriage from the origin
point.
Press [1] key (DEFAULT) if the cutting are is
not to change.
4 Press the [1] key (AREA).
SET LOWER LEFT screen is displayed.
5 Press the POSITION (
) key and move the tool carriage
to the position to be the lower left of the AREA.
6 Press the [ENTER] key (SET) once the tool carriage is in
correct position.
SET UPPER RIGHT screen is displayed.
Supplement
Please set the X and Y cut range for the areas
on the upper right and lower left points to at
least 10 mm.
An error message will appear for areas that
are too small.
You will need to reset the settings for the upper
right and lower left points.
7 Press the POSITION (
) key and move the tool carriage
to the upper right position of the AREA.
Supplement
It will return to AREA PARAMETERS setting
screen (2/2) without changing the settings
when you press the [4] key (CANCEL).
8 Press the [ENTER] key (SET) once the tool carriage is in
correct position.
Setting will be set, and it will return to AREA PARAMETER screen (2/2).
9 Press the [PAUSE/MENU] key.
It will return to default screen.
To Next Page
Loading...
