5-40
Adjust Automatically
Supplement
See "Adjust Manually"
P.5-41
if you are
moving manually to registration mark for
scanning.
This section describes the operation to adjust with registration mark
scan by moving to registration mark automatically after setting the
ARMS mode and POINTS.
Operation
Supplement
Press the [2] key (ARMS) in the MENU screen
if it is not ARMS SETTING screen.
1 Press the [1] key (AUTO READ MARKS) in the ARMS
SETTING screen (1/4).
Following message is displayed.
2 Press the POSITION (
) key and move the tool carriage
to the area to start scanning of the registration mark.
Supplement
Left gure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Registration mark scan area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Mode the tool inside
this area
Mode the tool inside
this area
100mm
100mm
Point 1 (point to make
origin point)
Point
4
Point
2
Point
3
Point
4
Point
2
Point
3
Point 1 (point to make
origin point)
Supplement
Scan the registration marks in accordance
with the setting of the MARK DISTANCE (see
"Setting Mark Distance"
P.5-14
).
It will return to default screen without
scanning when you press the POSITION ( )
key (CANCEL).
3 Conrm the position of the tool, and if it is OK, press the
[ENTER] key (SET).
Registration marks are scanned automatically. DISTANCE entry screen
is displayed once the scanning is completed.
To Next Page
Loading...
