GRAPHTEC CE6000 SERIES - Positioning of the Media and the Registration Mark

5-4
The area necessary to scan the registration mark when the mark distance is set is as following:
Do not print in the shaded area shown in the Figure below.
For 3POINTS For 4POINTS
MARK TYPE 2MARK TYPE 1 MARK TYPE 2MARK TYPE 1
Feed direction of media Feed direction of media Feed direction of media Feed direction of media
a
a
a
a
a
a
a
a
a
a
a
a=6mm a=6mm a=6mm a=6mm
Registration scanning area Registration scanning area Registration scanning area Registration scanning area
a
Supplement
See "Setting Shape (Pattern) of Registration Mark"
P.5-11
to change the shape (pattern) of the registration mark.
See "Setting Mark Distance"
P.5-14
for setting mark distance.
It may mistakenly detect as registration mark if there is anything else plotted within the registration scanning area. Adjust the
"MARK DISTANCE" so it can scan the registration mark correctly. (See "Setting Mark Distance"
P.5-14
)
Clean any dirt or foreign objects from the media. Any dirt or foreign object might be scanned mistakenly as registration mark.
Plot the registration mark in contrast easy to scan, such as black lines on white background. Adjust the scanning level of the
sensor if you need to use the colored or glossy media. (See "Adjusting the Sensor Level "
P.5-20
)
Positioning of the Media and the Registration Mark
Place the registration mark away from the edge of media to scan the registration mark.
Make sure the push roller location is outside of the Registration Mark.
Draw the Registration Mark as shown in the next image.
MARK TYPE 2MARK TYPE 1
Feed direction of media Feed direction of media
15*
30
12 32
Rightmost
push roller
Rightmost
push roller
Leftmost
push roller
Leftmost
push roller
Unit: mm
6 6 6 6
* When the expand limit is set
to 1 or more, it will be 10.