5-41
Supplement
Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value) is
displayed under that.
If the input value is not changed, it will assume
that there is no difference between measured
distance and the distance in the data.
Digits of settings can be changed by pressing
the [FAST] key.
4 Press the POSITION ( ) key and increase or decrease the
setting value.
Supplement
It will return to ARMS setting screen (1/4)
without changing the settings when you
press the POSITION ( ) key (CANCEL).
Distance input screen for point 3 is displayed
if it is set to 3POINTS or more, so repeat
steps 4 and 5 to set.
5 Conrm the setting and press the [ENTER] key (SET).
Adjustment by scanning the registration mark is completed, and it will
return to default screen.
Adjust Manually
Supplement
See "Adjust Automatically"
P.5-40
if you
are moving automatically to registration mark
for scanning.
This section describes the operation to adjust with registration
mark scan by moving to registration mark manually after setting the
ARMS mode and POINTS.
Operation
Supplement
Press the [2] key (ARMS) in the MENU screen
if it is not ARMS SETTING screen.
1 Press the [2] key (MANUAL READ MARKS) in the ARMS
SETTING screen (1/4).
Following message is displayed.
To Next Page
Loading...
