GRAPHTEC CE6000 SERIES - Set the Enlarge;Shrink Scale (Scale)

4-8
Supplement
Press the [2] key (OFF) to turn off the mirror.
4 Press the [1] key (ON).
Supplement
It will return to AREA PARAMETERS setting
screen (1/2) without changing the settings
when you press the POSITION ( ) key
(CANCEL).
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to AREA PARAMETERS setting
screen (1/2).
6 Press the [PAUSE/MENU] key.
The tool carriage moves to the coordinate position you set.
It will return to default screen.
Set the enlarge/shrink scale (Scale)
It can enlarge or shrink cutting.
The rate of enlargement or shrinkage of the cutting data can be changed by settings.
Reference
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
3 Press the [2] key (SCALE).
SCALE setting screen is displayed.