GRAPHTEC CE6000 SERIES - Setting Speed of the Registration Mark Scan

5-26
Setting Speed of the Registration Mark Scan
Speed of the tool carriage and media to scan the registration mark is set.
It may not scan the registration marks or the difference may become large when the speed is too high, but the
cutting time becomes longer when the speed is too slow. Adjust the setting value considering the balance.
It is normally set to "NORMAL", but the scanning might improve when it is set to "SLOW" in cases where the
registration marks cannot be scanned or the difference is too big.
Operation
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3 Press the POSITION ( ) key.
ARMS SETTING screen (4/4) is displayed.
4 Press the [1] key (SENSING SPEED).
SENSING SPEED screen is displayed.
5 Press the [1] key (SLOW) or the [2] key(NORMAL).
Supplement
It will return to ARMS SETTING screen (4/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
6 Conrm the setting and press the [ENTER] key (SET)
Setting will be set, and it will return to ARMS SETTING screen (4/4).
7 Press the [PAUSE/MENU] key.
It will return to default screen.