GRAPHTEC CE6000 SERIES - 7.6 Offset Force Settings

7-13
Slight cut operation is performed before the actual cut operation to align the blade toward the cutting direction.
Lower FORCE is necessary compared with the normal cutting, so it is possible to set lower FORCE as an
OFFSET FORCE.
OFFSET FORCE is used to control the rotation of the blade with the tangential emulation in addition to control the
blade direction at the beginning of the cut.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
TOOL setting screen (1/3) is displayed.
2 Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3 Press the [3] key (OFFSET FORCE).
OFFSET FORCE setting screen is displayed.
Supplement
CE6000-40/60 can be set from 1 to 31, and
CE6000-120 can be set from 1 to 38.
4 Press the POSITION ( ) key and increase or decrease the
setting value.
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOLS SETTING screen (1/3).
6 Press the [PAUSE/MENU] key.
It will return to default screen.
7.6
Settings for OFFSET FORCE