GRAPHTEC CE6000 SERIES - Setting the Tool up Move

8-11
"Tool up movement" is when you continuously receive tool up movement coordinate news from the computer
connected to the CE6000 and set whether to move to every coordinate in order or go directly to the last one.
There are following 2 settings for "TOOL UP MOVE".
ENABLED : If several coordinates are received continuously, it will move to each in order it is received.
DISABLED : If several coordinates are received continuously, it will directly move to the last coordinate received.
Cutting time can be reduced if it is set to "DISABLED", if the time to move the tool in raised status is wasteful.
Supplement
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3 Press the POSITION ( ) key.
TOOLS SETTING screen (3/3) is displayed.
4 Press the [1] key (TOOL UP MOVE).
TOOL UP MOVE setting screen is displayed.
8.6
Setting the Tool Up Move