GRAPHTEC CE6000 SERIES - Adjusting for the Registration Mark Scan Position

5-27
Adjusting for the Registration Mark Scan Position
Sensor to scan the registration mark is positioned away from the tip of the tool (pen tip). Therefore, it is
necessary to adjust the coordinate values of the scanned registration mark so it will match with the cutting
position.
If the registration mark is already marked on the media, scan that registration mark, plot another registration
mark in the same position, and measure the difference between them. This difference is entered as a adjustment
value.
If there is no registration mark on the media, plot a registration mark rst, scan that registration mark, plot
another registration mark, and measure the difference of them. This difference is entered as a adjustment value.
When using media and tools for actual use, the adjustment accuracy will be higher.
Reference
There is a restriction on the shape (style) of the registration marks that can be scanned. See "Shape (Pattern) of Registration Mark"
P.5-2
.
Adjust After Plotting the Adjustment Registration Mark
This section describes the steps to plot the registration mark.
Registration mark is to be plotted if there is no registration mark on the media to adjust the registration mark
scan position. Subsequently, it continues to "Adjusting the registration mark position".
Reference
Proceed to "Setting the Position Using ARMS"
P.5-35
without plotting the registration mark if the registration mark is already
drawn on the media.
Operation
Reference
See "Loading Media (Paper or Marking Film)"
P.2-5
for loading white media.
1 Load white media.
Reference
See "Attaching a Tool"
P.2-4
for setting
the water-based ber pen. If the water-based
ber-tip pen has been scratched, then it may
not read.
2 Set the water-based ber pen (black) on the tool holder 1
(Backward).
3 Press the [PAUSE/MENU] key.
MENU screen is displayed.
4 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.