GRAPHTEC CE6000 SERIES - 12.2 Replacing Cutter Blade

12-3
Replace the cutter blade by referring to the structure diagram of the cutter pen.
Supplement
See "Structure of Cutter Plunger"
P.2-2
for
the structure of the cutter plunger.
Cutter blade
Plunger
Blade-length adjustment knob
Plunger-cap
Hole
Cutter Plunger Structure
Operation
1 Turn the blade-length adjustment knob in the direction of the
B arrow and pull the blade into the plunger.
One scale unit
approximately 0.1 mm
Graduation
Graduation
2 Turn the plunger cap in the counter-clockwise direction to
remove it from the plunger.
3 Remove the blade from inside the plunger cap.
4 Remove a new blade from its pack. Insert the new blade into
the hole provided in the plunger cap.
5 With the blade inserted into the plunger cap, screw on the
plunger from above.
6 Fix the plunger cap by turning it clockwise.
12.2
Replacing Cutter Blade