GRAPHTEC CE6000 SERIES - A.1 Main Specifications

A-2
CE6000-40 CE6000-60 CE6000-120
CPU 32bit CPU
Conguration Grit-rolling plotter
Drive Digital servo
Max. Cut Area 375 mm × 50 m 603 mm × 50 m 1213 mm × 50 m
Guaranteed precision
cutting area*
1
356 mm × 2 m 584 mm × 5 m
(When using optional basket)
1194mm × 5 m
(When using optional basket)
Mountable media width*
2
Min: 50 mm
Max: 484 mm
Min: 50 mm
Max: 712 mm
Min: 85 mm
Max: 1346 mm
Available roll media diameter Max. diameter: 180 mm, Min. diameter: 76 mm
Max. cutting speed 600 mm/s (in all directions) 900 mm/s (45°direction) 1000 mm/s (45°direction)
The number of push roller 2 2 3
Speciable speeds (cm/s) 1 to 10, 15, 20, 25, 30, 35, 40,
45, 50, 55, 60
1 to 10, 15, 20, 25, 30, 35, 40,
45, 50, 55, 60, 64
(45°direction 90 cm/s)
1 to 10, 15, 20, 25, 30, 35, 40,
45, 50, 55, 60, 65, 70, 71
(45°direction 100 cm/s)
Cutting Pressure 0.2 to 2.94 N (20 to 300 gf) 31 steps 0.2 to 4.41 N (20 to 450 gf)
38 steps
Min. character size 5 mm (0.197 in.) alphanumeric Helvetica med. Font
Mechanical resolution 0.005 mm
Program mable resolution GP-GL : 0.1/0.05/0.025/0.01 mm
HP-GL*
3
: 0.025 mm
Repeatable accuracy*
1
Max. 0.1 mm/in unit of 2 m (Designated Film and Cut Conditions)
Number of cutters/pens 1
Usable pen type Water-based ber-tip and oil-based ballpoint
Compatible media Mono-vinyl chloride media, uorescent media, and reective media up to 0.25 mm thick
(Excluding high-intensity reective lm)
Interface RS-232C/USB2.0 (Full Speed)
Buffer memory 2 MB
Resident command sets GP-GL/HP-GL*
3
(Control panel switching, Auto switching)
LCD display Graphic type (240 × 128 dot)
Power supply AC100-120 V, 200-240 V, 50/60 Hz
Power consumption 120 VA
Operating environment 10 to 35℃, 35 to 75 % R.H. (non-condensing)
Guaranteed accuracy
environment
16 to 32℃, 35 to 70 % R.H. (non-condensing)
External dimensions
(W × D × H)
672 × 338 × 266 mm 900×593×1046 mm
(Including stand)
1541 × 736 × 1250 mm
(Including stand)
Weight 10.5 kg 21 kg (Including stand) 40.5 kg (Including stand)
*1: Varies depending on the type of Graphtec-authorized lm and the cutting conditions.
*2: The accuracy of minimum media width is when the push rollers are set to 5 mm from both edges of media.
*3: HP-GL is a registered trademark of the US Hewlett Packard Company.
A.1
Main Specications