GRAPHTEC CE6000 SERIES - Setting Length of the Overcut

7-4
Setting Length of the Overcut
Set the length of overcut with tangential emulation.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
2 Press the POSITION ( ) key.
CONDITION setting screen (2/3) is displayed.
3 Press the [3] key (OVERCUT).
OVERCUT setting screen is displayed.
4 Press the [1] key (Condition No.)
CONDITION No. selection screen is displayed.
5 Press the POSITION ( ) key and select the CONDITION
No.
6 Conrm the setting, and press the POSITION ( ) key
(PREVIOUS).
Condition No. is selected and return to OVERCUT setting screen.