1-3
Front View: CE6000-40
Cutting mat
Grit roller position guide
Cutting groove
Tool carriage
Tool holder
Control panel
Media set lever
USB interface connector
RS-232C interface connector
Push roller
Media sensor
Grit roller
Control panel ...........................Used to access various plotter functions.
Push rollers .............................Rollers that push the media against the grit rollers.
Grit rollers ................................Metallic rollers with a le-like surface that feed the media back and forth.
Media sensors .........................The front sensor is used to sense the leading edge of the media. The rear
sensor is used to sense the trailing edge of the media.
Tool carriage ............................Moves the cutter-pen or plotting pen across the media during cutting or
plotting.
Tool holder ...............................Holds the cutter-pen or plotting pen and moves it up or down.
Grit roller position guide ........Stickers on the front of the Y rail and the rear side of the top cover that show
the position of each grit roller. Use these alignment marks as an aid in locating
the Push rollers.
Cutting mat ..............................Cutter blade moved on this mat, preventing wears of the blade.
Cutting groove .........................Use this groove when using the media cutter.
Media set lever ........................Used to raise or lower the Push rollers during the loading or unloading of
media.
USB interface connector ........Used to connect the plotter to the computer with a USB interface cable.
RS-232C interface connector
..Used to connect the plotter to the computer with a RS-232C interface cable.
1.2
Nomenclature
To Next Page
Loading...
