GRAPHTEC CE6000 SERIES - 2.10 Selecting Tool Condition

2-32
In Simple mode, you can change tool conditions for ve different types of media.
Normal mode can remember up to 8 settings.
Changing these settings allows you to make the proper settings for each different type of media.
The [SIMPLE] key allows you to switch between Simple mode and Normal mode. Switching will reset the
machine.
Simple mode
Operation
Supplement
Use Normal mode for changing the type of
blade, offset, and acceleration.
Pushing the [4] key (RETURN) allows you
to return to the conditions screen without
changing the settings.
1 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/5) is displayed.
2 Press the POSITION ( ) key and select the setting.
Select previously registered media types (tool conditions).
3 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to default screen.
2.10
Selecting Tool Condition