GRAPHTEC CE6000 SERIES - Setting the Tool Condition

2-34
Setting the Tool Condition
Supplement
See the appropriate references for details
about the "Setting the Tangential Emulation"
P.7-3
, "Setting Length of the Overcut"
P.7-4
, "Setting the Distance Adjust"
P.7-14
, and "Setting of the Initial Down
Force"
P.7-6
.
For method to manually adjust the blade
length, see "Adjust the Blade Length
Manually"
P.2-44
and "Adjust the Blade
Length Automatically"
P.2-48
.
This section describes how to make the tool, speed, force,
acceleration, and tool number settings. Before cutting media, the
following ve cutter-pen conditions must be specied.
(1) Cutter-blade length .... Adjust the blade length by referring to the
media thickness table below.
(2) FORCE ...................... Set the FORCE by referring to the table
below.
(
3) SPEED ...................... Set the SPEED by referring to the table
below.
(
4) ACCELERATION ....... Set the ACCELERATION by referring to
the table below.
(5) OFFSET .................... Set to suit the cutter blade being used.
CAUTION
It may result to damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade length is set
less than the thickness of the media.
Tool Conditions (Cutter Blade) for Each Media Type
Media type Thickness (mm) Blade used Force Speed (cm/s) Acceleration
Film for outdoor use 0.05 to 0.08 CB09UB 10 to 14 30 or under 2
Film for decorative use 0.08 to 0.1 CB09UB 1
4 to 17 30 or under 2
Transparent or semitransparent lm 0.08 to 0.1 CB09UB 14 to 20 30 or under 2
Reective lm 0
.08 to 0.1 CB09UB 14 to 20 30 or under 2
Fluorescent lm 0
.20 to 0.25 CB09UB, CB15U 20 to 24 10 to 20 2
Car lm 0
.05 to 0.08 CB09UB-K60 14 to 20 5 to 15 2
Tool Conditions for Each Media Type (Simple mode: initial value)
Media type (LCD indications) Blade used
Standard Value
with Cut Pressure
(Force)
Speed (cm/s)
Film for outdoor use (For outdoor use) CB09UB (12)+0 20
Film for decorative use (For decorative use) CB09UB (15)+0 20
Transparent or semitransparent lm (Transparent lm) CB09UB (17)+0 20
Reective lm (Reective lm) CB09UB (17)+0 20
Fluorescent lm (Fluorescent lm) CB09UB (22)+0 15
Blade Part Nos., Displayed Blade Types, and CUTTER OFFSET Values
Blade material/tool Blade type
LCD panel indication
Setting
range
Setting value
for other
Blade (tool) type Default value
Ultra-hard blade CB09UB CB09U 0 ±5 19
CB15U CB15U 0 ±5 29
CB15UB CB15UB 0 ±5 7
CB09UB-K60 CB09U-K60 0 ±5 19
Other OTHER 1 1
to 45 –
Pen PEN N/A N/A 0
When a blade type has been selected, the OFFSET is automatically adjusted by ±5 with respect to the default
cutter offset value for that blade type.
Select OTHER to use settings other than those displayed for hard-to-cut media.
Select pen to set the plotting pen.