2-4
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its ange contacts the upper part of the holder and then tighten
the screw rmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or
whenever the tool is moving.
It is explained here using cutter plunger as an example.
CAUTION
When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
Mounting
1 Loosen the tool holder screw.
Bracket to hold tool
Tool holder
Tool holder
Bracket to hold tool
Top
2 While pushing up the tool holder, push until its ange
completely touches the upper part of the holder.
Bracket to hold tool
Tool holder
Flange
To Next Page
Loading...
