GRAPHTEC CE6000 SERIES - Move Away the Tool Carriage

3-5
Move Away the Tool Carriage
It is possible to move the tool carriage 100 mm toward upper right. It makes it easier to conrm the cutting
results if you perform this operation after the cutting is completed.
<When using Roll Media>: Seen from above
Position of the pen carriage before moving away
To the bottom of the cutting area
(machine origin point)
Standby position of the pen carriage
<When using Sheet Media>: Seen from above
To the top of the maximum
cutting area
Bottom of the operation area
(machine origin point)
Operation
Supplement
Tool carriage will move away to upper right by
continuously performing the same operation.
1 Press the [1] key (VIEW) in READY status.
Tool carriage will move away.
To move the tool carriage to the origin point, do following:
Operation
1 Press the [2] key (HOME) in READY status.
Tool carriage will move to the origin point.