GRAPHTEC CE6000 SERIES - 7.4 Setting Distance Adjust

7-9
DISTANCE ADJUST value corrects any deviation in the length of cut or plotted line segments, which occurs
depending on the media being used. DISTANCE ADJUST value for the deviation is specied as a percentage of
the total distance. For example, a setting of +0.05% adjusts a distance of 2 m (2,000 mm) by 2,000 x 0.05% = 1
mm, making 2,001 mm. DISTANCE ADJUST can be specied for each CONDITION No.
Supplement
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
2 Press the POSITION ( ) key.
CONDITION setting screen (3/3) is displayed.
3 Press the [1] key (DISTANCE ADJUST).
DISTANCE ADJUST setting screen is displayed.
4 Press the POSITION ( ) key and select the CONDITION
No.
5 Press the [1] key (ON).
DISTANCE ADJUST becomes on and [3] key (X) and [4] key (Y)
becomes enabled.
7.4
Setting the Distance Adjust