GRAPHTEC CE6000 SERIES - 7.5 Initial Blade Control Position

7-11
After turning on the power or changing pen condition settings, touch the blade to the media and adjust the blade
direction. The Initial Blade Control Position will need to be set in order to make sure the area is not damaged and
that the blade properly makes contact with the media.
Selecting [below 2 mm] will change the Initial Blade Control Position to 2 mm below the cutting start point (2 mm
from the edge of the point from which the media will be shifted.)
Selecting [Out of Range] will but the Initial Blade Control Position out of the range of the cutting area.
Feed direction of media Feed direction of media
2mm
Push roller
Initial Blade Control Position
Setting Point
(Set as"OUTSIDE")
Cut Start Point
(Cutting Origin Point)
Initial Blade Control Position
Setting Point
(Set as"2mm BELOW")
Cutting area
CAUTION
Selecting [Out of Range] and then changing the expand setting to a positive digit can damage the cutting mat.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3 Press the POSITION ( ) key.
TOOLS SETTING screen (2/3) is displayed.
7.5
Setting Initial Blade Control Position Adjust