GRAPHTEC CE6000 SERIES - Setting Origin Point When HP-GL Is Set

3-9
Setting Origin Point When HP-GL is Set
When using the HP-GL command, the origin point is set to either the lower left of the cutting area or the center.
Supplement
When using the GP-GL command, this setting does not affect the operation.
See "Settings of Controls from Computer"
P.11-1
about setting the COMMAND.
Operation
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
MENU screen
(Simple mode)
MENU screen
(Normal mode)
2 Press the POSITION ( ) key (I/F) in Normal mode, or press
the [2] key (I/F) in Simple mode
INTERFACE screen is displayed.
INTERFACE screen
(Simple mode)
INTERFACE screen
(Normal mode)
3 Press the [2] key (HP-GL ORIGIN POINT) in Normal mode,
or press the [1] key (HP-GL ORIGIN POINT) in Simple mode.
HP-GL ORIGIN POINT setting screen is displayed.
4 Press the [1] key (LOWER LEFT) or the [2] key (CENTER).
Supplement
It will return to I/F screen without changing the
settings when you press the POSITION [ ] key
(CANCEL).
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to I/F screen.
6 Press the [PAUSE/MENU] key.
It will return to the default screen.