GRAPHTEC CE6000 SERIES - 13.4 Confirm Cutting Data

13-18
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the transmission
of cutting data is performed correctly.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will
start to move immediately after selecting to print the dump list.
Supplement
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the display
of transmission data does not match. Check the transmission condition and the command.
If the command setting is "Auto", the dump list of the cutting data is not output. Please set the command to "GP-GL" or "HP-GL".
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1 Set a media larger than A4 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting
the pen tool.
For changing the tool conditions please refer
to "Selecting Tool Condition"
P.2-32
, and
for tool settings please refer to "Setting the
Tool"
P.2-38
.
2 Set the pen tool to the tool holder 1 (Backward) and select
the condition where the pen tool is set.
Supplement
Perform the settings in Normal mode.
3 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4 Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
13.4
Conrm the Cutting Data