GRAPHTEC CE6000 SERIES - Setting Registration Mark Size

5-12
Supplement
MARK TYPEs that the plotter can detect are 2
types shown in bottom left gures.
5 Press the [1] key (TYPE1) or the [2] key (TYPE2).
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Supplement
It will return to ARMS SETTING screen (2/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
6 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS SETTING screen (1/4).
7 Press the [PAUSE/MENU] key.
It will return to the default screen.
Setting Registration Mark Size
The size of registration mark you read out should be preset.
Size of the registration mark that can be set is from 4 mm to 20 mm.
If there is unbalance (skewing) or printing error present in the set media, it will be easier to detect registration
marks with larger sizes. However, if the registration mark is large, then the cutting area will become tighter.
Feed direction of media Feed direction of media
When detecting a registration mark, it will start from the lower left registration mark, and search next in horizontal
and vertical directions. If the print is tilted as shown left, short registration marks will be outside the detection
area.
If the registration marks are large like shown right, it can be detected even if the print is tilted.
It will be easier to detect using larger registration size when using a cutting data long in the media feed direction.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.