GRAPHTEC CE6000 SERIES - Detect the Registration Mark for Adjustment on the Media and Enter the Value

5-30
Supplement
Setting range is from -3.0mm to +3.0mm.
17 Press the POSITION ( ) key and increase or decrease the
setting value. Set the Y value measured in step 12.
18 Conrm the setting and press the POSITION ( ) key
(PREVIOUS).
SENSOR OFFSET is selected and it will return to SENSOR OFFSET
ADJ. screen.
Supplement
It will return to ARMS setting screen (3/4)
without changing the setting when you press
the POSITION ( ) key (CANCEL).
19 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS SETTING screen (3/4).
20 Press the [PAUSE/MENU] key.
It will return to the default screen.
Detect the Registration Mark for Adjustment on the Media and Enter the Value
Method to enter the adjustment value, which is the difference between the scanned registration mark on the
media and the cutting position, is described here.
Supplement
Plot the registration mark before going to following steps if there is no registration mark written on the media. See "Adjust After
Plotting the Adjustment Registration Mark"
P.5-27
to plot registration marks.
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-5
for loading the media.
1 Load the media with adjustment registration mark in the
plotter.
2 Press the [PAUSE/MENU] key.
MENU screen is displayed.
3 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.