GRAPHTEC CE6000 SERIES - Page 148

5-31
4 Press the POSITION ( ) key twice.
ARMS SETTING screen (3/4) is displayed.
Supplement
It will return to ARMS setting screen (3/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
5 Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. screen is displayed.
6 Press the [2] key (SCAN).
Following message is displayed.
7 Press the POSITION ( ) key and move the tool carriage
to the area to start scanning of the registration mark.
Feed direction of media
Align the tool to this area
Registration mark scan area
Supplement
It will return to ARMS SETTING screen (3/4)
without plotting when you press the [4] key
(CANCEL).
8 Conrm the position of the tool, and if it is OK, press the
[ENTER] key.
The registration mark for comparison is plotted after scanning the
registration mark (see below). It will return to SENSOR OFFSET ADJ.
screen once the plotting is completed.
Feed direction of media
Distance adjustment value Y
Distance
adjustment
value X
Registration mark
for adjustment
Registration mark
for comparison