GRAPHTEC CE6000 SERIES - Test the Registration Mark Sensor

5-24
Test the Registration Mark Sensor
CAUTION
This function performs cutting after the
registration mark is scanned. If a cutter is used
as the tool, it may harm the plotter.
If there still is a difference in the cutting, even after performing an
adjustment using the registration mark, it is possible to check if there
is a problem with the registration mark itself or the application by
evaluating the position of the registration mark plotted and detected
only using the plotter.
Operation
Supplement
Print the "Test Pattern 1" to test MARK TYPE
1, and "Test Pattern 2" to test MARK TYPE 2.
Standard registration mark is inside the
"ARMS Test Files" folder of the accessory
DVD.
Registration
Mark
File
Format
File Name
MARK TYPE 1 pdf ARMStest_type1.pdf
eps ARMStest_type1.eps
MARK TYPE 2 pdf ARMStest_type2.pdf
eps ARMStest_type2.eps
1 Print the standard registration mark in the accessory DVD.
MARK TYPE 1 MARK TYPE 2
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-5
for loading the media.
2 Load the printed media onto the plotter.
3 Press the [PAUSE/MENU] key.
MENU screen is displayed.
4 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
5 Press the POSITION ( ) key.
ARMS SETTING screen (4/4) is displayed.