GRAPHTEC CE6000 SERIES - 1.4 Connecting to the Computer

1-16
Connect the plotter to the computer using the interface cable. Use either the USB port, the RS-232C port to
connect the plotter to the computer. Select the port depending on the specication of the software to be used and
the availability of the interface port on the computer.
Please install driver software before connecting.
Depending on the port used, use either the USB cable, the RS-232C cable (CB0023C-HS: sold separately) to
connect. Use the cables specied by Graphtec, matching the computer that is to be connected.
This will be explained in CE6000-120.
Connection
1 Check that the power switch is turned off (the " " side is
pressed down).
Supplement
See the "Setting Interface"
P.9-2
about
setting the interface.
2 Connect the plotter to the computer using the interface cable.
USB cable
Computer
Connection via USB interface
Computer
RS-232C cable
(sold separately)
Connection via RS-232C interface
1.4
Connecting to the Computer