GRAPHTEC CE6000 SERIES - Chapter 2 Preparing to Cut

2-1
Chapter 2: Preparing to Cut
This chapter describes how to prepare to start the cutting.
PRODUCT SUMMARY
2.1 Preparation of Cutter Plunger
2.2 Attaching a Tool
2.3 Loading Media (Paper or Marking Film)
2.4 Aligning the Push Rollers
2.5 About the Default Scree
n
2.6 Connecting to the Power
2.7 How to Use Control Panel
2.8 Setting Feeding Metho
d
2.9 Pre Feed of Media (Paper or Marking Film)
2.10 Selecting Tool Condition
2.11 Running Cutting Tests
2.12 About Simple mode
2.12.1 Setting Page Length (Simple mode)
2.12.2 Origin Point Settings When conguring HP-GL (Simple mode)
2.12.3 GP-GL Step Size (Simple mode)
2.12.4 Display Language Settings (Language) (Simple mode)
2.12.5 Display Length Unit Settings (Length Unit) (Simple mode)