2-56
2.12.3 GP-GL Step Size (Simple mode)
Here you can change the distance of 1 Step. Match it to the software you are using.
"Command setting" is only for GP-GL commands.
Operation
1 In default screen, press [PAUSE/MENU] key.
MENU screen is displayed.
2 Press [2] key (I/F) .
INTERFACE screen is displayed.
3 Press [2] key (GP-GL STEP SIZE).
STEP SIZE setting screen is displayed.
4 Press [1] key (0.100 mm), [2] key (0.050 mm), [3] key (0.025
mm), or [4] key (0.010 mm).
Supplement
Press the POSITION ( ) key to return to the
interface menu without changing any settings.
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE screen.
6 Press [PAUSE/MENU] key.
It will return to default screen.
To Next Page
Loading...
