4-7
Setting Mirror
There is a function to mirror the cutting by reversing the origin point and coordinate axes.
Set the MIRROR setting on to do mirroring.
Reference
This setting will be saved even if the power is shut off.
MIRROR mode off
MIRROR mode on
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
3 Press the [4] key (MIRROR).
MIRROR setting screen is displayed.
To Next Page
Loading...
