GRAPHTEC CE6000 SERIES - Setting Offset between the Registration Mark and Cutting Origin Points

5-18
Setting Offset Between the Registration Mark and Cutting Origin Points
You can set the cutting point after the registration mark is read.
The default offset for the registration mark is 0.0 mm on X and Y, and can be changed to any point from -1000.0
to +1000.0 mm.
Feed direction of media
Moved origin point (Cutting Point)
X offset
Y offset
Registration mark (point 1)
Origin point after registration mark is read
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3 Press the POSITION ( ) key.
ARMS SETTING screen (2/4) is displayed.
Supplement
It will return to ARMS SETTING screen (2/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
4 Press the [4] key (AXIS ORIGIN OFFSET).
AXIS ORIGIN OFFSET screen is displayed.