GRAPHTEC CE6000 SERIES - Page 136

5-19
5 Press the [1] key (X).
X AXIS setting screen is displayed.
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
Setting range is from -1000.0 to +1,000.0mm.
6 Press the POSITION ( ) key and increase or decrease the
setting value.
7 Conrm the setting and press the POSITION ( ) key
(PREVIOUS).
Offset value will be selected, and it will return to AXIS ORIGIN OFFSET
mode screen.
8 Press the [2] key (Y).
Y AXIS setting screen is displayed.
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
Setting range is from -1000.0 to +1,000.0mm.
9 Press the POSITION ( ) key and increase or decrease the
setting value.
10 Conrm the setting and press the POSITION ( ) key
(PREVIOUS).
Offset value will be selected, and it will return to AXIS ORIGIN OFFSET
mode screen.
Supplement
It will return to ARMS SETTING screen (2/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
11 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS SETTING screen (2/4).
12 Press the [PAUSE/MENU] key.
It will return to default screen.