GRAPHTEC CE6000 SERIES - 13.3 Create Test Pattern

13-16
Create a self-test pattern to check the operation of the plotter.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will
start to move immediately after selecting to plot the test pattern.
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1 Set a media larger than A3 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting
the pen tool.
For changing the tool conditions please refer
to "Selecting Tool Condition"
P.2-32
, and
for tool settings please refer to "Setting the
Tool"
P.2-38
.
2 Set the pen tool to the tool holder 1 (Backward) and select
the condition where the pen tool is set.
Supplement
Perform the settings in Normal mode.
3 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4 Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
5 Press the [2] key (SELF TEST).
SELF TEST start screen is displayed.
6 Conrm that the pen tool is set.
13.3
Creating Test Pattern