GRAPHTEC CE6000 SERIES - Adjust the Blade Length (Automatic Height Adjust)

2-48
Adjust the Blade Length (Automatic Height Adjust)
Test cutting must be performed several times in order to conrm the optimal blade length setting. However, if the
blade length adjustment function is used, the optimal length can be easily set.
Operation
1 Load the media for test cutting in the plotter.
2 Press the POSITION ( ) key the tool carriage to the
location you wish to perform the blade length adjustment.
Supplement
Perform the settings in Normal mode.
3 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
4 Press the POSITION ( ) key.
CONDITION setting screen (3/3) is displayed.
5 Press the [3] key (BLADE ADJUST).
Message prompting to turn the blade-length adjustment knob is
displayed.
Supplement
See "Structure of Cutter Plunger"
P.2-2
for
bladelength adjustment knob.
6 As instructed, turn the blade length adjustment knob to the
left to fully retract the blade.
Blade