2-49
Supplement
Adjustment is only possible for the cutter
pen set in Tool Holder 1 (Backward). It does
not apply to Tool Holder 2 (Forward) . See
"Attaching a Tool"
P.2-2
for instructions on
setting.
7 Set the cutter Plunger in Tool Holder 1 (Backward).
8 Press the [ENTER] key.
You can calculate the height by moving the tool up and down.
TO ACHIEVE THE TARFET LENGTH screen is displayed.
9 Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen (TARGET) is displayed.
10 Press the POSITION ( ) key and increase or decrease the
setting value.
11 Conrm the settings and press the ENTER key (SET).
The Blade Length Target will be selected, and you will return to the TO
ACHIEVE THE TARGET LENGTH screen.
Supplement
"T" is the target value of the blade length, and
"H" is the current blade height (amount) .
Turning the blade-length adjustment knob
displays the number of turns and direction.
12 Press the [2] key (CHECK).
You can calculate the height by moving the tool up and down.
The amount and direction to turn the adjustment knob is displayed.
To Next Page
Loading...
