2-50
CAUTION
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
13 Turn the blade-length adjustment knob and adjust the cutter
blade length.
[2] Current blade length is displayed by pressing the [2] key
(CHECK) , so adjust the blade length until it matches the
thickness of the media.
14 Press the [3] key (END).
Adjustment is completed and it will return to CONDITION screen (3/3).
15 Press the [COND/TEST] key.
I will be return to default screen. After completing the settings, press
[ENTER] key.
To Next Page
Loading...
