13-11
Other Error Messages
Symptom LCD Display Possible Cause Solution
E01001
to E01005
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01006 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01007 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01008 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01009 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01010 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01011 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01012 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01013 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01014 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01015 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01017 The plotter is defective.
Load on the motor was too large.
Move the object disturbing the operation,
and turn on the plotter after turning it off
once.
Do not use heavy media.
To Next Page
Loading...
