GRAPHTEC CE6000 SERIES - Page 228

13-10
Symptom LCD Display Possible Cause Solution
E04013 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04014 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04015 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04016 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04017 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04018 Media set lever was lowered. Reload the media and try again.
E04019 There was cancel operation by the user. Redo the process.
E04020 There is a defect in the detection settings
value.
Check the settings value.
E04021 Registration mark was not detected in the
auto detection area.
Check the media. Check the print position
of the registration mark.
E04022 There was cancel operation by the user. Redo the process.
E04023 Registration mark was not detected. Redo the sensor level adjustment.
Change the color of the registration mark.
Check the media.
Check the print position of the registration
mark.
E04024 Registration mark was not detected. Redo the sensor level adjustment.
Change the color of the registration mark.
Check the media.
Check the print position of the registration
mark.
E04025 Registration mark was not detected. Redo the sensor level adjustment.
Change the color of the registration mark.
Check the media.
Check the print position of the registration
mark.