GRAPHTEC CE6000 SERIES - Setting the Force

2-41
Setting the Force
Set the cutting force that is used in each of the condition numbers.
Setting range : CE6000-40 : 1 to 31
: CE6000-60 : 1 to 31
: CE6000-120 : 1 to 38
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3)
without changing the settings when you press
the [4] key (CANCEL) .
2 Press the [4] key (FORCE).
FORCE setting screen is displayed.
* Display may vary depending on the selected condition number.
3 Press the POSITION ( ) key and select the condition
number (CONDITION No.).
Supplement
Guideline to set force
See "Setting the Tool Condition"
P.2-32
.
4 Press the POSITION ( ) key and increase or decrease the
setting value.
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
6 Press the [COND/TEST] key.
It will return to default screen.