2-38
Setting the Tool
Set the type and offset value of the tool that is used in each of the tool condition numbers.
Operation
Supplement
Perform the settings in Normal mode.
In Simple mode, CB09U is locked.
1 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION ( ) key (CANCEL).
2 Press the [2] key (TOOL).
TOOL setting screen is displayed.
3 Press the [1] key.
CONDITION No. selection screen is displayed.
* Display may vary depending on the selected condition number.
4 Press the POSITION ( ) keys to select the Condition No. of
the Tool/Offset you wish to change.
5 Conrm the setting and press the POSITION ( ) key
(PREVIOUS) .
CONDITION No. will get set and return to TOOL setting screen.
6 Press the POSITION ( ) key, and set the tool.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION ( ) key (CANCEL) .
Tools that can be selected are as following:
CB09U, CB15U, CB15U, OTHER,
CB09U-K60 PEN
To Next Page
Loading...
