GRAPHTEC CE6000 SERIES - Outline of Manual Position Adjust; Setting of Mark Scan Mode and Number of Adjustment Marks

6-2
With manual position adjust, tilt of the axes are adjusted using the 2POINTS, 3POINTS, or 4POINTS adjustment
marks (grits or registration marks) as a standard. The distance between each points can also be entered to adjust
the distance.
Move the tip of each tool to the appropriate point.
Use magnier or light pointer as a tool to match each points.
Use the media with prints (adjustment marks such as grits or registration marks) necessary to get XY axes and
origin point.
Setting of Mark Scan Mode and Number of Adjustment Marks
To perform the AXIS ALIGNMENT, set the MARK SCAN MODE to "AXIS ALIGNMENT".
Select the number of the registration marks (adjustment marks) from 2POINTS, 3POINTS, or 4POINTS when the
MARK SCAN MODE is set to "AXIS ALIGNMENT". Position of each adjustment marks are as following.
2POINTS
First point or origin point
Second point
3POINTS
First point or origin point
Second point
Third point
4POINTS
First point or origin point
Second point
Third point
Fourth point
6.1
Outline of Manual Position Adjust