2-6
Both roll media and sheet media can be used with the CE6000. Load the media according to the instructions
given for each type.
Use the grit roller on the right side of the media (looking from the front) as a guide when setting it in the media
sensor. Afterwards, adjust the push roller so that it's lined up with the side of the media.
P.2-6
Loading Roll Media (CE6000-40)
P.2-9
Loading Roll Media (CE6000-60/120)
P.2-14
Loading Sheet Media (CE6000-40/60)
P.2-16
Loading Sheet Media (CE6000-120)
Loading Roll Media (CE6000-40)
Operation
1 Lower the media set lever to raise the push rollers.
Media set lever
Push roller
Media sensor
2 Put the roll media on the roll media tray and then push the tip
of the roll media forward from the back of the machine. Make
sure to pull it so that there is no slackening across the roll
media's route.
2.3
Loading Media (Paper or Marking Film)
To Next Page
Loading...
